Sartorius Flexsafe Pro - Ending the Process Data Acquisition

Operating Instructions Flexsafe
®
Pro Mixer Drive Unit 47
Operation
Procedure
t Slowly pull the device away from the Palletank
®
for mixing until the rear
guide rollers are at the end of the guide rails of the Palletank
®
for mixing.
The device must roll away over the 2 rolling elements on the guide rails
of the Palletank
®
for Mixing.
t Pull the handle upwards slightly so that the rear guide rollers glide
downwards from the guide rails of the Palletank
®
for Mixing.
t Continue to slowly pull the device away from the Palletank
®
for mixing
until the front guide rollers are at the end of the guide rails of the
Palletank
®
for mixing. The device must roll away over the 2 rolling
elements on the guide rails of the Palletank
®
for Mixing.
t Press the handle downwards slightly so that the front guide rollers glide
from the guide rails of the Palletank
®
for Mixing.
t If the device was used at a lower temperature than the temperature at
the installation site where the device is intended to be used next: Accli-
matize the device (see Chapter “6.2”, Page31).
t WARNING Risk of injury from power supply when not in use! If the
device is temporarily not in use: Switch off the device. Disconnect the
power supply at the installation site and secure the power supply cable
to the device’s cable reel.
8.13 Ending the Process Data Acquisition
Requirements
The mixing process is complete.
Procedure
t Remove the USB stick from the device.
t Seal the connection with the cover cap.