Sartorius Flexsafe Pro - Installation; Scope of Delivery and Setup

28 Operating Instructions Flexsafe
®
Pro Mixer Drive Unit
Installation
5 Installation
5.1 Scope of Delivery
Item Quantity
Flexsafe
®
Pro Mixer Drive Unit 1
Screw to replace the transport lock screw 2
Country-specific power supply cable (EU) 1
Country-specific power supply cable (USA) 1
Potential equalization cable, combined with power supply
cable and additional power supply plug
1
Operating instructions 1
Technical documentation 1
5.2 Unpacking the Device
Procedure
t Unpack the device.
t If the device is stored temporarily: Observe the storage information (see
Chapter “15.2 Ambient Conditions”, page 57).
5.3 Prerequisites for Assembly at Installation
Site
Procedure
t Make sure that the following conditions are met at the installation site:
Condition Features
Ambient conditions Suitability tested (see Chapter “15.2 Ambient Conditions”, page 57)
Setup surface − Stable and level surface
− Sufficient space for the device and for moving the device (see Chapter
“15.1 Dimensions and Weight”, page 57 for required dimensions)
− Sufficient load-bearing capacity for the device and the peripheral
devices even when full (device weight see Chapter “15.1 Dimensions
and Weight”, page 57; weight of the peripheral devices see
instructions for the peripheral devices, e.g. Palletank
®
for Mixing)
Suitability of Palletank
®
for Mixing and
mixing bag
The suitability of the Palletank
®
for Mixing and mixing bags has been
checked (suitability, see Chapter “6.1.2 Connecting the Power Supply
Cable”, page 30).