Sartorius Flexsafe Pro - Coupling and Decoupling Procedure

Operating Instructions Flexsafe
®
Pro Mixer Drive Unit 19
Device Description
3.5 Coupling and Decoupling the Device on the
Palletank
®
for Mixing
3
1
2
6
5
4
Fig. 4: Device coupled with Palletank
®
for Mixing and decoupled from Palletank
®
for Mixing
(example)
Pos. Designation Description
1 Alignment pins coupled The alignment pins have risen and
are connected to the alignment
plate of the Palletank
®
for Mixing.
2 Motor coupled The motor has risen and the
impeller is seated in the impeller
holder of the motor.
3 Distance sensor coupled The distance sensor has risen. The
required distance from the
Palletank
®
for Mixing has been
achieved.
4 Motor decoupled The motor has been lowered and
separated from the impeller in the
mixing bag.
5 Alignment pins decoupled The alignment pins have been
lowered and separated from the
Palletank
®
for Mixing.
6 Distance sensor decoupled The distance sensor has been low-
ered into the initial position.
3.6 Acoustic Signals
The device gives off acoustic signals while the motor is being raised and
lowered.