Operating Instructions Flexsafe
®
Pro Mixer Drive Unit 45
Operation
Procedure
t Press the [Error] or [Warning] button.
y The error list appears.
t To switch between the entries in the error list: Press the [List up] or [List
down] button.
t Check the entries in the error list:
t To call up the information for a message: Press the [Info] button.
t To call up the details for a message: Press the [Details] button.
t Resolve the fault, that has triggered the error message or warning
message (see Chapter “10 Malfunctions”, page 49).
t If the fault has been corrected: Confirm the message. To do so, press the
[Confirm] button.
y The mixing process continues.
8.11 Viewing Recorded Messages
All recorded messages are saved. The in and out times of a message are
marked by a time stamp. If the message memory is full: The oldest messages
are deleted.
Procedure
t Call up the “System information” menu in the administration menu.
t Press the [Error history] button.
y The messages received are shown in a list:
− Status K: In time of the message
− Status KG: Out time of the message after confirmation by the user
t To switch between the entries in the error list: Press the [List up] or [List
down] button.
8.12 Ending the Mixing Process
8.12.1 Decoupling the Device from the Impeller and
Palletank
®
for Mixing
To decouple the device from the Palletank
®
for mixing and the impeller: The
motor, the alignment pins and the distance sensor must be lowered into the
original position.
Requirements
− The mixing process is complete.
− The “Separate motor” display appears in the user guide.
To Next Page
Loading...
