Operation 59
The selections of the individual fields determine which fields are displayed and
accessible during an integrity test, as well as which fields will be printed out on the
Sartocheck
®
4 plus Filter tester’s internal printer.
Note: Fig. 7-75 is valid for the protocol settings of the combined diffusion
and bubble point test.
Management Unit Parameters
In the submenu “Management Unit Parameters”, you can set the following options:
F3: Edit parameters
Edits the management unit software parameters
F4: Save parameters to SD card
Saves the management software configuration file on SD card
F5: Save parameters to network
Saves the management software configuration file on the network in
the corresponding FTP directory
F6: Load parameters from SD card
Loads the management software configuration from SD card
F7: Load parameters from network
Loads the management software configuration from the corresponding
FTP directory in the network
F8: Print parameters
Prints the parameters of the management unit software
F9: Set standard parameters
Sets back the factory default parameters
Fig. 7-75 | Service Menu: Software configuration
Fig. 7-76 | Service Menu: Software configuration
Fig. 7-77 | Service Menu: Software configuration
To Next Page
Loading...
