Sartorius Sartocheck 4 plus - Technical Specifications

Sartorius Stedim Biotech GmbH cannot assume liability if Sartocheck
®
4 plus test
units are subjected to improper use or improper operation. Sartorius Stedim Biotech
is not liable for any damages resulting therefrom. The operator bears the sole risk.
Proper use also includes compliance with operating, inspection and maintenance
conditions prescribed by the manufacturer. Non-compliance with the warnings in
the operating instructions and installation instructions, in particular, constitutes
improper use of the equipment. Only EMC-tested control leads and accessories may
be used. Units may only be returned in their original boxes or appropriate secure
packaging. No liability can be accepted for transport damage.
2.3 Technical Specifications
2.3.1 Dimensions and Weight Sartocheck
®
4 plus Filter tester
Length: 460 mm
Width: 390 mm
Height: 245 mm
Weight: 15 kg
Packing Weight: 2.7 kg
Sartocheck
®
4 plus Filter tester MultiUnit
Length: 460 mm
Width: 390 mm
Height: 150 mm
Weight: 13 kg
Packing Weight: 2.7 kg
2.3.2 Connection Data Sartocheck
®
4 plus Filter tester | Sartocheck
®
4 plus Filter tester MultiUnit
Power requirements
Operating voltage: 100-240 V/±10%
Number of phases: 1 Ph/N
Neutral conductor: Loadable N (in the Appendix)
Grounding conductor: Separate SL (yellow-green) (in the Appendix)
Frequency: 47-63 Hz
Protection rating: IP 44
Installation: According to VDE regulations
Permissible voltage fluctuation: ± 10% from normal value
Maximum operating pressure: 10 bar g
Operating pressure: min. 4 bar g
Maximum power input: 74 Watt
Internal limit pressure: 10 bar g
2.3.3 Pneumatics Sartocheck
®
4 plus Filter tester | Sartocheck
®
4 plus Filter tester MultiUnit
Required compressed air 4–9 bar g
Water, oil and particle free
2.3.4 Test Media Sartocheck
®
4 plus Filter tester | Sartocheck
®
4 plus Filter tester MultiUnit
Test gas: Compressed air, dehydrated and deoiled
Wetting fluid: Water or as described with the process validation
documents for the filter cartridge to be tested
Overview and Proper Use 7