18 Weigh Cell Operating Instructions
Getting Started
6 Getting Started
6.1 Installing the Power Supply
Unit
WARNING
Fatal electric shocks can be caused by using incorrect
power plug adapters or improper use of the power plug
adapters!
t Attach the country-specific power plug adapter to
the power supply unit.
t Do not insert the power plug adapter into the socket
without a power supply unit.
Item number
on packaging
Power supply unit YEPS01-15VOH
with connection cable and coun-
try-specific power plug adapters
(packed in PE bag with printed
country code, e.g., EU)
YEPS01-PS1 USA, Japan and Canada (US,
JP+CAN), Europe and Russia
(EU+RU), Great Britain (UK)
YEPS01-PS2 Argentina (AR), Brazil (BR),
YEPS01-PS3 China (CN), Australia (AU),
Procedure
t Select the country-
specific power plug
adapter. The power plug
adapter must be suitable
for use with the wall
outlet at the installation
site.
t Insert the power plug
adapter into the power
supply unit. The grooved
button must be facing
forwards.
t Push the power plug adapter as far as you can until it
clicks into place.
t Check whether the power plug adapter is securely
locked in place by pulling it gently.
y If the power plug adapter does not move: It is locked
in place.
6.1.1 Dismantling the Power Plug Adapter
Procedure
t Press the grooved
button from above and
pull back on the power
plug adapter.
t Push the power plug
adapter out of the
power supply unit and
remove it.
6.2 Connecting the Power Supply
Procedure
t
WARNING Serious injuries caused by using
defective power supply cables! Check the power
supply cable for damage, e.g., cracks in the insulation.
t If required: Contact Sartorius Service.
t Check whether the country-specific power plug
matches the power supplies at the installation site.
t If required: Replace the country-specific power
plug adapter.
t If required: Contact Sartorius Service.
t NOTICE Damage to the device due to excessive
input voltage! Check whether the voltage
specifications on the manufacturer’s ID label match
those of the power supply at the installation site.
t If the input voltage is too high: Do not connect
the device to the power supply.
t Contact Sartorius Service.
t Only use original Sartorius power supply units.
t Insert the right-angle plug of the power supply unit
into the electronics module and tighten the screw.
t Connect the mains plug to the wall outlet (supply
voltage) at the installation site.
y After connecting the power supply: “Power” LED
illuminates in green.
y The power supply is provided via the DC jack
(Hirschmann plug).
t If the supply voltage specified or the plug design of
the AC adapter do not match the local rating or
standard, please contact your Sartorius office or
dealer.
To Next Page
Loading...
