Weigh Cell Operating Instructions 41
Operation
8.7.3 Buttons
Symbol Designation Description
[On/Off] button — When the button is pressed: Switches the operating display on.
— If the button is held down: Switches the operating display off.
[Menu] button — When the button is pressed: The settings menu opens.
— If the button is held down: It switches to version display.
[Zero] button Zeroes the device.
[Tare] button Starts taring.
[Print] button Exports the readouts to the integrated data interfaces.
[Change] key — If the key is briefly pressed: Sets the preload.
— If the key is held down: Deletes the preload.
[isoCAL] button If the button is flashing: Starts the isoCAL function.
If the button is not flashing: Starts the set calibration and adjustment function.
[Adjust] button Starts the set calibration and adjustment function.
[GLP] button Exits the GLP printout and starts printing the GLP footer.
[Unit Toggle]
button
If the “Unit Toggle” function is active:
— If the button is held down: Accesses the “Unit Toggle” function menu.
— When the button is pressed: Switches between the basic unit display and up to
4 other units.
[Back] button — In the menu:
— When the button is pressed: Returns to the previous display.
— If the button is held down: Saves the menu settings.
— When entering digits: Selects the previous digit position.
— For an active application: Exits the application and deletes the set reference
value.
[Up] button — In the menu: Scrolls through the menu levels or the available parameters.
— When entering digits: Increases the displayed value.
— In the main display of an active application: Switches to the display of the
current weight value/parameter.
[Down] button — In the menu: Scrolls through the menu levels or the available parameters.
— When entering digits: Decreases the displayed value.
— In the main display of an application that is not active: Accesses the display to
set the reference values.
— In the main display of an active application: Switches to the display of the
current weight value/parameter.
[Confirm] button — In the menu: Accesses the displayed menu level or confirms the displayed
parameter.
— When entering digits: Selects the next digit position.
— In the main display of an application that is not active: Starts the application
process and saves the set reference value.
— In the main display of an active application: Adopts the next component or the
next parameter.
To Next Page
Loading...
