Sartorius WZB25-NC - Menu Structure, Main Menu with the YRD01 Display Unit

Weigh Cell Operating Instructions 43
Operation
8.7.5 Menu Structure, Main Menu with the YRD01 Display Unit
t Navigating the menus (see Chapter “8.7.6 Menu Navigation with YRD01 Display Unit”, page 44).
Level 1 Level 2 Description
SETUP BALANCE Set the functions of the device.
GEN.SERV.
“General services”
Reset the menu to factory settings.
DEVICE RS-232
“RS232, 9-pin”
Define the parameters for the COM interface.
USB
“USB-C”
Define the parameters for the USB interface.
Extras Define the functions of the operating display.
DATA OUTP.
“Data output”
COM. SBI
“SBI communication”
Configure the automatic data output.
PRNT.PAR.
“Settings for the
printout”
Perform the settings for the printout.
PC.DIREC.
“Direct transfer of data
(PC)”
Define the output format for the data exchange between the
weigh cell and the PC
APPLIC.
“Applications”
WEIGH Determine the weight value of a sample.
Activate the functions for all applications.
COUNT Determine the number of parts that have approximately equal
weight.
PERCENT
“Percent weighing”
Determine the percentage share of a
sample based on a reference weight.
NET.TOT.
“Net total”
Carry out the weighing of components for a mixture.
TOTAL
“Totalizing”
Add weight values of independent weighing processes in a
memory.
ANIMALW.
“Animal weighing”
Weigh unstable samples, e.g., animals. This program calculates
the average of several measurement cycles.
CALC.
“Calculation”
Calculate the weight value using a multiplier or divisor, e.g., for
determining the weight per unit area of paper.
DENSITY
“Density
determination”
Determine the density of solid samples based on the buoyancy
method.
INFO
“Device information“
VERSION
“Version number”
Display the software version number.
SER. NO.
“Serial number”
Display the device’s serial number.
Model Display the device’s model designation.
LANGUAGE Set the menu language of the operating display.