42 Weigh Cell Operating Instructions
Operation
8.7.4 Displays in the Operating Display
Symbol Designation Description
[Counting] display Indicates that the “Counting” application is selected.
[Percent weighing]
display
Indicates that the “Percent weighing” application is selected.
[Calculation] display Indicates that the “Calculation” application is selected.
[Animal weighing]
display
Indicates that the “Animal weighing” application is selected.
[Net total] display Indicates that the “Net total” application is selected.
[Totalizing] display Indicates that the “Totalizing” application is selected.
[Density
determination]
display
Indicates that the “Density determination” application is selected.
[Busy] display Indicates that the device is processing a command.
[Sign] display Indicates whether the value being displayed is positive or negative.
[Zero] display For some conformity-assessed devices: Indicates that the device has been
zeroed.
[AUTO] display Indicates that the “Animal weighing” application starts automatically.
[R12] display Indicates the active range for multi-range balances.
[Percent] display Indicates that a percentage value is being displayed.
[Net] display Indicates that a net value is being displayed.
[Gross] display Indicates that a gross value is being displayed.
[Selection] display — In the menu: Identifies the selected parameter.
— If the “Density determination” application is active: Indicates that a
calculated value is being displayed.
[Unit symbol]
display
Indicates the set weight unit, e.g., [g] for “grams”.
[Quantity] display Indicates that a quantity is being displayed.
Display
[Invalid weight
value]
— Indicates that the display does not contain a weight value, but is instead the
calculated result of an application, e.g., for the “Animal weighing”
application.
— For conformity-assessed devices: Indicates a fault. The cause of this fault is
displayed after pressing the [Unit Toggle] key.
To Next Page
Loading...
