Weigh Cell Operating Instructions 21
System Settings
For the models WZB254-N | -ND | -NC, WZB653-N
|
WZB1402-N | -NC
t Carefully screw in the
customer-supplied
load holder on the M3
thread (2): Observe the
maximum screw-in
t NOTICE The screw-in
depth may not exceed
t If required, install a
draft protection shield.
For the model WZB8202-NC
t Carefully screw in the
customer-supplied
load holder on the M4
thread (2): Observe the
maximum screw-in
t NOTICE The screw-in
depth may not exceed
t If required, install a
draft protection shield.
For the model WZB8202-N
t Carefully screw in the
customer-supplied
load holder on the M4
thread (1).
t If necessary, insert an
anti-twist mechanism
into the adjacent
t Install a draft shield if
necessary
2
2
2
1
To Next Page
Loading...
