Satec System 295 User Manual

Operating The PM295 47
To enter a sub-menu:
Ä From the upper window, select the sub-menu entry with the up/down arrow
keys.
Ä Press SELECT to enter the selected sub-menu. For instructions on operating
sub-menus, see the paragraphs below.
To quit the secondary menu and return to the primary menu:
Ä Press SELECT to choose the upper window.
Ä Press ENTER to return to the primary menu.
Viewing and Changing a Setpoint Condition
Each condition sub-menu displays the setup parameters for one of four setpoint
triggers. For information on specifying setpoint triggers, refer to Section 4.17.3. To
enter a sub-menu, choose one of the entries Cnd1 to Cnd4 in the upper window
using the up/down arrow keys, then press SELECT. The following illustrations show
the sub-menu windows:
Cnd1
ConJ
Or
Cnd1
GrP
rt.Hi
Cnd1
InP
cur
Cnd1
Cond
GE
Cnd1
On
3000
Cnd1
OFF
2950
Conjunction
operation
(Or/And)
Trigger
parameter
group
Trigger
parameter
name
Operate
condition
(GE/LE
Eq/nE
On/OFF
nEU)
Operate
limit
Release
limit
To view the trigger parameters:
Ä From the central window, scroll through the list of parameters with the up/down
arrow keys. The lower window will display the current parameter setup.
All trigger parameters that can be used for setpoint operation are organized in
groups that are listed in Table B-6 (see Appendix B) with the corresponding group
label. The trigger parameter is defined by both the parameter group and parameter

Satec System 295 Specifications

General

Brand	Satec
Model	System 295
Category	Measuring Instruments
Language	English