Satel GSM-X - Page 45

SATEL GSM-X 43
Managing notifications
Messaging priority – if this option is enabled, when during the telephone connection of
device connected to the telephone line output an event occurs which is to be notified by
the module, the connection will be terminated. If this option is disabled, the messaging will
only be realized when the device connected to the telephone line output completes the
call.
Messaging sounds – if this option is enabled, the module will generate a sequence of
sounds every 2 seconds during voice messaging to signal the events presented in the
table below (where: dot – short sound, dash – long sound).
Event Tone sequence
Input 1 violation
•
Input 1 restore
– •
Input 2 violation
• •
Input 2 restore
– • •
Input 3 violation
• • •
Input 3 restore
– • • •
Input 4 violation
• • • •
Input 4 restore
– • • • •
Output 1 ON
• • –
Output 1 OFF
– • –
Output 2 ON
• • – –
Output 2 OFF
– • – –
Output 3 ON
• • – – –
Output 3 OFF
– • – – –
Output 4 ON
• • – – – –
Output 4 OFF
– • – – – –
Telephone line trouble
– – •
Telephone line restore
– – –
Test transmission
– – – –
New external event
– – – •
Reporting trouble
– – – – •
Reporting OK
– – – – –
AC power failure
– – – – – •
End of AC power failure
– – – – – –
Battery trouble
– – – – – – •
Battery restore
– – – – – – –
Test transmission with module status – if this option is enabled, module status information
is sent in SMS message to notify of the “Test transmission” event.