46 GSM-X SATEL
regardless of what kind of identifier is to precede the event code, receiving it will result in
sending the message.
Format – format in which the event code must be received so that the module can send
notification of the event. You can select: 4/2, Contact ID or SIA. Double click to change the
format.
CODE – event code, after receiving of which notification of the event will be sent. For 4/2
format, enter 2 characters (digits or letters from A do F). For Contact ID or SIA format, you
can use the code editor. To open the code editor window, click on the button available
in the “Event” field.
Z/M/U – number of zone / module / user that must be included in the received code so that
the module can send notification of the event. The field applies to SIA and Contact ID
formats.
R – the option applies to Contact ID format. If it is enabled, the received event code refers to
event restore / arming. If it is disabled, the received event code refers to a new event.
EVENT – event description. The field refers to SIA and Contact ID formats. It is
autocompleted after entering the event code into the “CODE” field.
Push – event category. You can assign the event to one of the following categories: 1: Alarm
/ 2: Violation / 3: Restore, / 4: Output control, / 5: Input block / 6: Diagnostics / 7: Other / 8:
Push to all. Double click on the field or enter a digit from 1 to 8.
T1...T8 – messaging method selected for the given telephone (see “Users” p. 52):
[blank field] – no messaging,
s – SMS messaging,
c – CLIP messaging,
sc – SMS and CLIP messaging.
Double click on the field or enter letter s, c or letters sc to define the messaging method.
SMS/Push msg. – the contents of SMS message which will be sent after receiving the
selected event code. The message may be composed of up to 32 characters.
7.14 SMS/DTMF control
You can control the module via SMS messages containing appropriate control commands as
well as by using keypad of the telephone (DTMF codes) from which connection to the module
was established. The SMS messages must be sent to the number of the SIM card currently
in use.
Local control tel. number – code triggering the DTMF local control function. You can enter
up to 16 digits. Entering the code from the keypad of telephone connected to the
telephone line output will allow you to control the module (see p. 57).
Confirm SMS control – if this option is enabled, after receiving an SMS message with
control command, the module will confirm the receipt by sending a return SMS message
with the module status.
SMS function – function run on receiving the control command / code.
SMS command – control command which can be sent in the SMS message to run the
function assigned to the command. You can enter up to 16 alphanumeric characters
except spaces (digits, letters and special characters). For some functions, the command
sent in the SMS message must have a specified form:
Forward USSD code – SIM 1/SIM 2 – allows you e.g. to check the account balance of
SIM card installed in the module. The required command form is: “xxxxxx=yyyy.” or
“xxxxxx=yyyy=”, where: “xxxxxx” – control command, “yyyy” – USSD code supported
by the GSM network operator. The module will use the USSD code contained in the
To Next Page
