SATEL GSM-X 47
command and will send the reply received from the operator to the telephone number
from which the control command was sent.
Change test transmission period – allows you to program the interval after which a test
transmission will be sent. The required command form is: “xxxxxx=M” or
“xxxxxx=H:M”, where: “xxxxxx” – control command, “M” – number of minutes after
which the transmission will always be sent, “H:M” – hour and minute when the
transmission will be sent once a day (enter Greenwich Mean Time (GMT)).
Change user 1…8 tel – allows you to program the number of telephone user. The
required command form is: “xxxxxx=yyyy.” or “xxxxxx=yyyy=”, where: “xxxxxx” –
control command, “yyyy” – new number of telephone user. It is recommended that the
telephone number be preceded by the country code.
The content of control commands must vary.
The content of one control command must not be inserted into the content of another
command.
It is not advisable to use the advanced functions available due to the USSD service if
menu is presented in response to the entered code.
The control command for sending USSD codes can be used for sending SMS
messages through the module.
Fig. 38. “SMS/DTMF Control” tab.
DTMF – control code that can be entered after establishing connection to the module from
telephone keypad to run the selected function. The code must contain 4 digits.
To Next Page
