Satel GSM-X - Local Update; Remote Update; Initiating the Update by Using SMS Message; 14 Restoring the Factory Settings

SATEL GSM-X 61
13.1 Local update
1. Download the update program for GSM-X module firmware from www.satel.eu.
2. Connect the module USB MINI-B socket with the computer USB port.
3. Run the update program for module firmware.
4. Click on the button.
5. When a prompt window is displayed asking you whether to continue the firmware update,
click “Yes”. The firmware of module will be updated. If the GSM-X-ETH module is
installed, its firmware will be updated too.
13.2 Remote update
1. Program the parameters for remote update of the module firmware in the module (see
“Remote update” p. 51).
2. Initiate the update from the GX Soft program (see p. 51) or by using an SMS message.
13.2.1 Initiating the update by using SMS message
The SMS messages which initiate the download and update of firmware can only be
sent from an authorized telephone number (see “Tel. numbers verification
(SMS/DTMF control and answer to CLIP)” p. 27).
1. Send to the number of SIM card used by the module an SMS message containing control
command to initiate firmware download from the “UpServ” update server (see “SMS
command” p. 52). If the “Update server address in SMS” option is enabled in the module
and you want the module to connect to an update server other than that indicated in the
module settings, the message should look like this: xxxx=aaaa:pp= (“xxxx” – control
command; “aaaa” – server address (IP address or domain name); “pp” – port number).
2. Completion of the new firmware download will be indicated by the module with an SMS
message.
3. Send an SMS message containing the control command to initiate the module firmware
update (see “SMS command” p. 52). If the update initiating control command has not
been programmed in the module, the firmware update process will be star
ted
automatically by the module after the download is completed.
4. Completion of the module firmware update will be indicated by the module with an SMS
message.
If any errors in the module firmware make its update impossible, enter the starter
mode to update the firmware (see description of RESET pins p. 9).
14. Restoring the factory settings
1. Click on the “Data” tab in the GX Soft program.
2. Click on “Factory settings” button. You will be prompted whether to restore the factory
settings.
3. Click on “Yes”.