32 GSM-X SATEL
Options
Pulsed – if this option is enabled, the output is pulsating when it is active.
Problem with transmission to station 1 / 2 – if this option is enabled, the output will be
active in the case of any problem with transmitting events to the monitoring station 1 / 2.
Telephone line trouble – if the option is enabled, the output is active in case of the analog
telephone line trouble. The time during which the problem must occur for the output to be
activated can be defined in the “Mainboard” tab (see “Telephone line loss delay” p. 26).
GSM trouble – if this option is enabled, the output is active in case of a problem with logging
into the GSM network. The time during which the problem must occur for the output to be
activated can be defined in the “Mainboard” tab (see “GSM network loss delay” p. 26). The
problem wit
h logging into the GSM network can be caused by:
missing SIM card,
entering a wrong PIN code,
missing or damaged antenna,
unavailable GSM network (out of range),
telephone damage.
7.7.3 Triggering
You can define whether and how the inputs are to control the outputs. The table lines present
the inputs, and the columns present the outputs of the module. If you want the input violation
to change the output state, select one of the available options in the selection field at the
intersection of the corresponding line and column:
- – input does not control the output.
1. ON – violation of the input will activate the output.
2. OFF – violation of the input will deactivate the output.
3. ON FOR TIME – violation of the input will activate the output for the time programmed in
the “Operating time” field (see p. 31).
4. TOGGLE – violation of the input will switch the output to its opposite state.
7.8 Communication
Fig. 30. “Communication” tab.
To Next Page
