SATEL GSM-X 5
Remote administration of the alarm system by using a computer with GUARDX program
installed (fast data transfer via GPRS).
Work in conjunction with STAM-2 monitoring station
SMS or CLIP receiving capability for monitoring station.
SMS sending capability for monitoring station.
Operation from mobile devices
Free GX Control application for remote operation of the module.
Functions available from the application:
checking the state of inputs and outputs,
blocking / unblocking inputs,
output control,
viewing troubles,
viewing event log.
Simple and easy establishing remote communication between GX Control application and
the module thanks to SATEL's connection setup service.
Configuring
Free GX Soft program for local (USB port) and remote (GPRS/Ethernet) configuring of the
module.
Simple and easy establishing remote communication between GX Soft program and the
module thanks to SATEL's connection setup service.
Possibility to configure the module settings by using SMS messages.
Firmware update
Local firmware update by using a computer connected to USB MINI-B port.
Remote update of the module firmware by using the “UpServ” server via GPRS or
Ethernet (the latter optionally, if GSM-X-ETH module is installed).
LEDs
LEDs indicating the module status.
Power supply
Powering with 12 V DC (±15%).
Connector for SATEL's dedicated power supply unit.
3. Typical module applications
The extended functionality of GSM-X module enables it to be used for a variety of
applications. This section presents typical examples of its application. Some of them are
capable of being combined with one other.
3.1 Backup communication path
When connected to the telephone line output (T-1 and R-1 terminals), the devices are
capable of making telephone calls via analog telephone line or GSM network. You can select
which communication path will be the primary one. If the primary communication path is
malfunctioning, the module can automatically switch over to the backup one.