SATO CL6NX - Page 124

6 Installation of Options
122
CL4NX/CL6NX Service Manual
7 Slide to attach the media holder plate 0
back and tighten three screws
".
Refer to step 4 for the positions of three screws ".
8 Place the spring ) and rewind core
unit
* through the rewind shaft +.
Rotate the rewind core unit * such that the
groove on the inner core nested on the protruding
tab of the torque limiter.
Properly nested rewind core unit allows the
E-ring
 to lock on the rewind shaft +.
9 Insert the oiles bearing  to the center
hole of the rewind core unit
*.
10 Using a pliers, attach the E-ring  to the
groove of the rewind shaft
+.
10
11
Slide
17
Inner view of
rewind core
16
18
19
Torque limiter
20
Fully inserted
19
18
20