SATO CL6NX - Dispenser Problem

3 Troubleshooting
34
CL4NX/CL6NX Service Manual
3.1.7 Dispenser Problem
Category
Symptom
Cause Remedy
Maintenance
NO
Dispenser
Is the
print mode set
correctly?
YES
Does not stop
at specified
position
NO
Is the
dispenser
sensor OK?
YES
Replace the
dispenser sensor
Refer to 4.4.1 in
CL4NX/CL6NX
operator manual
Set the print
mode to
Dispenser
Replace the
CONT PCB
Refer to 5.5
Replacing the Main
(CONT) PCB