SATO CL6NX - Removing the Housing Cover; Remove the Left Housing Cover

5 Replacement
68
CL4NX/CL6NX Service Manual
5.1 Removing the Housing Cover
Before you remove the covers of the printer, power off the printer. Disconnect the power cord and all
cables attached to the printer.
5.1.1 Remove the Left Housing Cover
Required tool:
• Phillips screwdriver (JIS #2 or equivalent)
1 Make sure that the printer is in power off
mode, then disconnect the power cord
from the AC outlet.
2 Loosen and remove the screw ..
3 Slide and lift in the arrow direction to
remove the left housing cover
3.
4 Perform the assembly, attach the left
housing cover with the reverse
procedure.
Note
When removing the left housing cover, make sure that
the cover does not touch the PCB, causing the
components of the PCB to be deformed.
Slide
& Lift
2
1