SATO CL6NX - Page 149

6 Installation of Options
147
CL4NX/CL6NX Service Manual
28 Connect the RFID signal cable  from
the RFID PCB assembly
 to the
EXT PCB
.
Connect the connector with a looped wire to the
EXT PCB as shown.
29 Connect two antenna wires to the
RFID PCB assembly
.
Take note on the position of the antenna wires
as shown. Connect the antenna wire from the
print head to the left connector. Connect the
antenna wire from the media guard to the right
connector.
30 After connection, fix the antenna wires
using the mini clamp as shown.
31 Attach the front covers 1and / to the
printer using two screws
$.
Slide in the arrow direction to attach the
front covers.
29
33
CAUTION
Mini
clamp
From media
guard
From print
head
35
4
5
3