SATO CL6NX - Page 16

2 Operation and Configuration
14
CL4NX/CL6NX Service Manual
RFID
Tools > Service > RFID
Set the functions for RFID.
The setting items are as follows:
1 RFID Mode Enable or disable the RFID mode.
2 Module Shows the type of RFID module installed on the
printer.
3 Region Set the region where you use the printer.
*Shows only if you have installed the UHF
RFID module.
4 Inventory Check Enable or disable the inventory check function.
*Shows only if you have installed the UHF
RFID module.
5 Inventory Timeout Set the timeout period of the inventory check.
*Shows only if you have installed the UHF
RFID module.
6 Verify Enable or disable the verification of data written
on tag.
7 PREND Type 3/4 Set the external output signal of the PREND.
RFID Mode
Tools > Service > RFID > RFID Mode
Enable or disable the RFID mode.
When RFID Mode is set to Enabled, the RFID menu shows in the
Interface mode menu.
The options are as follows:
• Enabled: Enable the RFID mode.
• Disabled: Disable the RFID mode.
Module
Tools > Service > RFID > Module
Shows the type of RFID module installed on the printer.