SATO CL6NX - Powering On;Off the Printer

4 Checking and Performing Printer Adjustments
65
CL4NX/CL6NX Service Manual
CL6NX Printer
Required tool:
• Phillips screwdriver (JIS #2 or equivalent)
1 Make sure that the printer is in power off mode, then disconnect the power cord from
the AC outlet.
2 Remove the gearbox of the liner rewinder from the printer.
Refer to Section 5.16 Replacing the Timing Belt for Liner Rewinder (Optional) for details.
3 Loosen the screw . of the tension
bracket 3.
Note
Do not remove the screw.
4 Check the condition of the timing belt $.
Make sure that there is tension on the timing belt.
5 Tighten the screw . of the tension
bracket.
6 If the tension of the timing belt is not
enough, replace the timing belt.
Refer to Section 5.16 Replacing the Timing Belt
for Liner Rewinder (Optional) for details.
7 Perform the assembly with the reverse
procedure.
1
2
3