SATO CL6NX - Page 98

5 Replacement
96
CL4NX/CL6NX Service Manual
6 Remove four screws $ and remove the gearbox / of the liner rewinder.
7 Remove three screws 1 and remove the rewind drive unit 4.
8 Remove the E-ring 2, gear pulley (and replace the timing belt ,.
Loosen the screw " in case the tension of the timing belt is tight.
9 Perform the assembly with the reverse procedure.
After the replacement
• Adjust the tension of the timing belt.
Refer to Section 4.14 Adjusting the Timing Belt Tension of the Optional Liner
Rewinder.
• Check that the liner rewind operation is correct.
4
3
7
6
4
5
8
9
10