SATO FX3-LX - Page Setup

70
Page Setup 4.1
[Stock]
Select the default stock from the registered stock. If you select [Custom], you can set [Width],
[Height], and [Sensors] on this screen.
[Custom stock has ID 257]
This check box enables compatibility with older SATO drivers that require a custom stock ID of
greater than 256.
[Copies]
Specify the number of labels to be issued.
[Width]
This setting shows the width set for the stock that you selected. If you select [Custom] for [Stock],
you can change the settings on this screen.
[Height]
This setting shows the height set for the stock that you selected. If you select [Custom] for
[Stock], you can change the settings on this screen.
[Media type]
This setting shows the sensor set for the stock that you selected. If you select [Custom] for
[Stock], you can change the settings on this screen. You can select [Continuous labels], [Labels
with gaps], or [Labels with black marks].
[Black mark position]
You can set the media type. This setting can only be configured when [Media type] is set to
[Labels with black marks]. Select from [Bottom black mark] and [Top black mark].