Custom Commands 4.5
You can directly control the printer by using custom commands. You can use features that are not
directly supported by the printer driver. Knowledge of Sato Barcode Printer Language (SBPL) is
necessary to use custom commands. For details of SBPL commands, refer to "FX3-LX Programming
Reference."
Custom command insert position
Before print job
Insert a command before a new print job. This setting affects all print jobs.
Before first page
Insert a command at the top of the first page in one file of data.
Before each page
Insert a command at the beginning of each page in one file of data.
Before elements on each page
Insert a command before an element on each page in one file of data.
After elements on each page
Insert a command after elements on each page in one file of data.
After each page
Insert a command at the end of each page in one file of data.
After last page
Insert a command at the end of the last page in one file of data.
After print job
Insert a command after the print job finishes.
To Next Page
Loading...
