SCANCLIMBER SC4000 - Page 101

ERECTION AND DISMANTLING
23
SC4000 Pos 4
V23C_09.13
9. Test the function of bottom limit switch
S11.
When lowering the platform it will
stop on the bottom position.
10. Test the function of the hooter safety
sensor B2.
When lowering the platform, the
hooter will be activated on its func-
tion area.
11.
Test the function of the platform elec-
tric box signal push-button S2. The
hooter should function by pressing
the push-button S2.
12. Assemble the third mast section
and the second part of hooter limit
sig nalling bar.
Assemble following two mast sec-
tions.
Drawing 4.16. Inductive safety sensor.
MAX. 8 mm-
MIN. 3 mm
B1
8. Test the function of the mast section
installation safety sensor B1. When
lifting the platform and the in ductive
safety sensor B1 runs over the last
mast section top, the platform stops
imme di ately.
13. After assembling of the rst ve mast
sections the test of the safety brake
should be carried out.
14. Platform driving control can be
realised by:
a) using the drive buttons located on
the platform electric box + OP2,
- connect the special plug -X5.1 to the
socket -X5
0
-Q2.1
-S2
-Q2
-A1
option:
thermostat
-E1/-E2
+OP2
-P1
-X5
-X22
-XS7
-X8
9999h
1
-H3
Option:
drive hour
meter
-S7
-S1
-S8
STOP
E
M
E
R
G
E
N
C
Y
Drawing 4.17 Platform driving control
realised by the drive buttons located
on the platform electric box + OP2