ERECTION AND DISMANTLING
35
SC4000 Pos 4
V23C_09.13
Drawing 4.35. Adjustment of the stabilizing mechanism.
V200076
3
5
4
B
A
15. Test the function of the bottom limit
switch S11.
When lowering the platform it will
stop on the bottom position.
16
. Test the function of the hooter safety
sensor B2.
When lowering the platform, the
hooter will be switched on its func-
tion area.
17. Test the function of the platform elec-
tric box signal push-button S2.
The hooter should function by press-
ing the push-button S2.
18. Adjust the stabilizing mechanism:
- Drive the lower platform up to the
same level with intermediate plat-
form. Adjust the stabilizing mecha-
nism with help of the stabilizing rod
(4) in the drawing below so that the
limit switch roller will t to the hole on
the plate (5). Limit switch in 0-posi-
tion.
Drawing 4.34. Inductive safety sensor.
MAX. 8 mm
MIN. 3 mm
B1
14. Test the function of the mast section
installation safety sensor B1. When
lifting the platform and the in ductive
safety sensor B1 runs over the last
mast section top, the platform stops
immediately.
To Next Page
Loading...