www.scheppach.com
GB
|
43
9. Layout
Your log splitter is not completely assembled for pack-
aging reasons.
Note:
Due to the high product weight, we recommend
the assembly to be carried out by at least two peo-
ple.
You require the following for assembly:
• 2x open-ended spanner / socket spanner, size
13mm
• 1x open-ended spanner / socket spanner, size
16mm
• 1x 8mm Allen key
• Grease or spray oil
Assembly material is not included in the scope of de-
livery.
9.1 Fitting the transport wheels (11) (Fig. 4, 4a)
1. Slide the wheel axle (F) through the holes on the
bottom, rear end of the log splitter.
2. Fit a washer (G) on both sides.
3. Fit the transport wheel (11) onto the wheel axle (F).
Then x them with one washer (G) and one split
pin (H) each. Bend the split pin (H) around slightly.
4. Then attach the wheel caps (I) on both sides.
9.2 Fitting the control arms (6) (Fig. 5, 5a)
Note: The operating arms (6) are marked L (left)
and R (right).
1. Pull out the cotter pin (28) from each and remove
the retaining bolt (26).
2. Apply a light lm of grease or spray oil to the up-
per and lower support points (6a) of the operating
arms (6).
3. Attach the operating arm (6). At the same time,
guide the rocker switch (27) through the slot in the
operating lever (16).
4. Fix the operating arms (6) with the retaining bolt
(26) by aligning the holes and attaching the retain-
ing bolt (26).
5. Now secure the retaining bolt (26) with a cotter pin
(28).
6. Repeat the process on the opposite side.
Wear hearing protection.
Excessive noise can result in a loss of hearing.
The specied noise emission values have been meas-
ured in accordance with a standardised test procedure
and can be used to compare one power tool with an-
other.
The specied device emissions values can also be
used for an initial estimation of the load.
Warning:
• The noise emission values can vary from the spec-
ied values during the actual use of the power tool,
depending on the type and the manner in which the
power tool is used, and in particular the type of work-
piece being processed.
• Try to keep the stress as low as possible. For exam-
ple: Limit working time. In doing so, all parts of the
operating cycle must be taken into account (such as
times in which the power tool is switched off or times
in which it is switched on, but is not running under
a load).
8. Unpacking
• Open the packaging and carefully remove the de-
vice.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the device and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the rst time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m WARNING!
Danger of choking and suffocating!
The packaging material, packaging and transport safe-
ty devices are not children‘s toys. Plastic bags, foils
and small parts can be swallowed and lead to choking.
- Keep packaging material, packaging and transport
safety devices away from children.
To Next Page
Need help?
General
