www.scheppach.com
52
|
GB
17. Troubleshooting
The following table shows fault symptoms and describes remedial measures in the event of your machine failing to
work properly. If you cannot localise and rectify the problem with this, please contact your service workshop.
Fault Possible cause Remedy
Motor (21) is running,
splitting column (1) does
not move up.
Motor (21) turns in the wrong direction. Turn the phase inverter in the power
connection (see point 10.6).
The motor (21) ends
the splitting process
automatically.
Overvoltage protective device was
triggered.
Call a qualied electrician.
The splitting column (1)
only moves down slowly.
Not enough oil available. Check oil level with oil dipstick (30)
screwed in.
Screws on the control lever (16) are
loose.
Tighten the screws on the control lever
(16).
Bleed screw (23) is closed. Loosen the bleed screw (23) two turns
before use.
Check if the cap nut (stroke setting bar)
(31) of the stroke setting bar (33) is loose.
Tighten the cap nut (stroke setting bar)
(31) of the stroke setting bar (33). If
necessary, t a new cap nut.
Log is not split.
Log splitter loaded incorrectly. Insert the log correctly.
Splitting wedge (2) is blunt. Grind the splitting wedge (2).
Oil leaks. Locate the leak, contact the dealer.
Splitting column (1)
vibrates,
generates noises.
Low oil and excess air in the hydraulic
system.
Check the oil level, top up if necessary,
otherwise contact the dealer.
Splitting column (1)
vibrates strongly in the
upper position.
Plastic guides are worn out. Replace the plastic guides at the top and
bottom.
Hydraulic pump whistles.
Too little hydraulic oil in the hydraulic oil
tank (24).
Top up hydraulic oil.
Oil leakage at splitting
column (1)
or in other places.
Trapped air in the hydraulic system
during operation.
Loosen the bleed screw (23) two turns
before use.
Bleed screw (23) not tightened before
transport.
Tighten bleed screw (23) before
transport.
Oil drain screw (25) loose. Tighten the oil drain screw (25) rmly.
Oil valve and/or seals defective. Contact dealer.