Schiller ARGUS LCM PLUS - Operation with External DC Voltage; Switching off and Disconnecting from Mains; Interruption of the Mains Supply

3Operation
3.2 Switching off and disconnecting from mains
Page 16
Art. no.: 2.510474 rev.: d
ARGUS LCM/PLUS
3.1.3 Operation with external dc voltage
3.2 Switching off and disconnecting from mains
3.2.1 Interruption of the mains supply
Important
Before initial operation with external dc voltage, check voltage supply. (The voltage
must be in the range of 11-30 VDC). On connection, make sure that the polarity is
correct.
1. Press the on/off button. A dialogue window appears.
2. Select with the left button YES and confirm the selection with the enter button.
3. Remove the mains cable from the mains supply socket (2) (see Fig. 3.1) to isolate
the device from the mains.
Important
If no dialogue window appears, it is possible to switch off the device by keeping the
On/Off button pressed for 10 seconds.
If the mains supply is interrupted, the device automatically switches over to battery
operation. The user settings are maintained. These settings can be saved in the
menu About+/Software.