Schmalz SCPSi - Individual Functions

5 Operating and Menu Concept
EN-US · 30.30.00.00424 · 07 · 10/23 25 / 86
5.4.2Displaying Data in the System Menu
1. Open the system menu by simultaneously pressing the MENU and UP buttons for more than 3 sec-
onds.
ð During activation, -5- appears.
2. Use the UP or DOWN button to select the value to be displayed.
3. Confirm the selection with the MENU button.
ð The value is displayed.
4. To save and exit the menu, press and hold the MENU button for at least 2 seconds.
5.5Individual Functions
Displaying the vacuum level:
Outside of the menu, the ejector is in display mode and the current vacuum level is displayed.
In display mode, a specific function is assigned to each button.
Displaying the supply voltage:
4 Press the UP button
ð The supply voltage that is currently applied to the ejector is displayed in volts.
After 3 seconds, the screen returns to the vacuum display.
The displayed voltage is a guideline value and is used for comparative measurements.
Displaying the operating mode:
4 Press the DOWN button
ð The current operating mode is displayed.
It is either standard I/O (SIO) mode [510] or IO-Link mode [10L].
In IO-Link mode, you can also press the DOWN button again to view the IO-Link Standard (1.0, 1.1) that is
currently in use.
After 3 seconds, the screen returns to the vacuum display.