SETTINGS SHEET Page 10 OF 10
FOR THE SEL-321/321-1 RELAY Date
(1 A NOMINAL RELAY)
Date Code 20011026
Global Contact Input Settings
Input Contact 1 Assignment: IN1 = _________
Input Contact 2 Assignment: IN2 = _________
Input Contact 3 Assignment: IN3 = _________
Input Contact 4 Assignment: IN4 = _________
Input Contact 5 Assignment: IN5 = _________
Input Contact 6 Assignment: IN6 = _________
Input Contact 7 Assignment: IN7 = _________
Input Contact 8 Assignment: IN8 = _________
* Input Contact 9 Assignment: IN9 = _________
* Input Contact 10 Assignment: IN10 = _________
* Input Contact 11 Assignment: IN11 = _________
* Input Contact 12 Assignment: IN12 = _________
* Input Contact 13 Assignment: IN13 = _________
* Input Contact 14 Assignment: IN14 = _________
* Input Contact 15 Assignment: IN15 = _________
* Input Contact 16 Assignment: IN16 = _________
Received M
IRRORED BIT 1: RMB1 = _________
Received M
IRRORED BIT 2: RMB2 = _________
Received M
IRRORED BIT 3: RMB3 = _________
Received M
IRRORED BIT 4: RMB4 = _________
Received M
IRRORED BIT 5: RMB5 = _________
Received M
IRRORED BIT 6: RMB6 = _________
Received M
IRRORED BIT 7: RMB7 = _________
Received M
IRRORED BIT 8: RMB8 = _________
* INPUT9 - INPUT16 available only on two I/O board relays.
* OUT17 - OUT32 available only on two I/O board relays.
Miscellaneous Global Settings
Front panel timeout: (0 - 30 minutes) FP_TIMEOUT = _________
Group change delay: (0 - 900 seconds) TGR = _________
CR RAM Diagnostics Action: Restart Enable (Y/N) ERESTART = _________
Serial Port Settings (See
Appendix G
for LMD and
Appendix H
for MIRRORED BITS)
Protocol (SEL, LMD, MB, MB8) PROTOCOL = _________
Baud Rate (300 - 38400) SPEED = _________
Data Bits (6, 7, 8) DATA_BITS = _________
Parity (O, E, N) PARITY = _________
Stop Bits (1, 2) STOP = _________
Timeout (0 - 30 min) TIMEOUT = _________
Send Auto Messages to Port (Y, N) AUTO = _________
Enable Hardware Handshaking (Y, N, MBT) RTS_CTS = _________
Fast Operate Enable (Y, N) FAST_OP = _________
To Next Page
Loading...
