EasyManua.ls Logo

Schweitzer Engineering Laboratories SEL-321 - Section 1: Introduction

Schweitzer Engineering Laboratories SEL-321
396 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Date Code 20011203 Manual Change Information iii
SEL-321/321-1 Instruction Manual
Revision
Date
Summary of Revisions
990331
Section 3: Communications: Updated Tables 3.11 and 3.12 in to include MB8
protocol. Changed ® to ¯ on page 3-43.
Appendix H: Updated to include MB8 protocol.
Section 6: Installation: Updated figure captions for Figures 6.2, 6.4, and 6.12.
Deleted Figure 6.11. Renumbered subsequent figures.
Section 2: Specifications: Changed variables “(X, Y, Z, W, or Z)” to the
correct variables “(V, W, X, Y, or Z)” listed on page 2-22.
Appendix A: Changed “event reported” to the correct “event reports” on
page A-9.
Appendix I: Replaced Figure I.15.
981030
Updated Figure 1.3 in Section 1: Introduction to reflect new current
transformer shorting connector.
Incorporated “Electronic-Level Input Option” addendum into Section 1:
Introduction.
Added front and rear panel drawings, Figure 6.11: SEL-321 Relay Horizontal
Front and Rear Panel Drawings (One I/O Board Plug-In Connector Version;
16 high-current interrupting outputs with shared return terminals) in
Section 6: Installation.
Replaced Figures 6.13, 6.14, 6.15, and 6.16 in Section 6: Installation with
Figures 6.14 and 6.15.
Revised manual to change model references for the current transformer shorting
connector and for respective wiring harness part numbers. See Note, Rear-
Panel Plug-In Connectors Option (Figure 6.10 through Figure 6.13),
Section 6.
Corrected pagination on pages 7-17 through 7-24.
Revised Figure B.1 in Appendix B: SEL-321 Main Board Jumper, Connector,
and Socket Locations.
980812
Updated Appendix A: Firmware Versions. Improved diagnostics.
980715
Updated Appendix A: Firmware Versions.
980529
Updated Appendix A: Firmware Versions. Changed series compensation
logic. Changed long memory constant time to 31.75 cycles.
980320 Updated hardware references throughout entire manual.
Changed ERESTART default to Y.
Revised Section 6: Installation.
Added low-level test interface to Section 7: Maintenance and Testing.
Revised Figure 3.1.
Added Appendix I: Interface Board Specifications.

Table of Contents

Related product manuals