Operating site
- Maintenance:
îš¾ Clean the entire operating site regularly with suitable cleaning materials.
îš¾ The presence of dangerous or combustible materials inside premises must be limited to the operating requirements.
- Access:
îš¾ Prohibit free access to persons who are not part of the establishment, except for those designated by the user.
- Respecting the environment:
îš¾ Drain and dispose of engine oil in a specially provided container (fuel distributors can collect your used oil).
îš¾ Burning of waste in the open air is prohibited.
îš¾ Remove waste water, sludge and other waste in a specialised processing centre.
1.4.2 Electrical safety precautions
ELECTRICAL EQUIPMENT - RISK OF ELECTRIC SHOCKS
DANGER
- Read the manufacturer's identification plate carefully. The values for voltage, power, current and frequency are shown. Check
that these values match the installation being supplied.
- The electrical connections must be made in accordance with current standards and regulations in the country of use and the
neutral system sold.
- Ask a qualified electrician to intervene when there are specific cases requiring equipment to be connected to an existing
electrical network.
- Disconnect the power to the equipment (equipment voltage, battery voltage and network voltage) before any installation or
maintenance operation is performed.
- Connect the equipment wires by respecting the wiring diagram supplied by the manufacturer.
- Always handle the equipment with dry hands and feet.
- Take all the necessary precautions to avoid touching stripped cables or disconnected connectors.
- Use and maintain the cables in good condition, well insulated and connected correctly and securely.
- Only replace equipment that provides protection against electric shock with identical equipment (specifications and nominal
values).
- Only use flexible durable cables with a rubber covering, which conform to ECI 245-4, or equivalent cables.
- Refit the protective plates (blanking covers) after each maintenance operation.
Note
: The electrical equipment supplied with the equipment complies with standard NF C15.100 (France), or with the standards of the
countries in question.
To Next Page
Loading...
Need help?
General
