EasyManuals Logo

SDMO R33C3 User Manual

SDMO R33C3
244 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #160 background imageLoading...
Page #160 background image
8-3
Chapter 8 PERIODIC INSPECTION AND MAINTENANCE PROCEDURES
Fuel filter - Drain water
Drain water for the fuel filter if the warning of water
draining for fuel filter is occurred.
1. Place a drip tray under the drain hose.
2. Loosen the drain plug and drain water from the fuel
filter.
Fig. 8-3 Fuel filter - Drain water (1)
3. Feed fuel by pushing down on the priming pump
(about seven strokes) to facilitate draining.
4. After draining, tighten the drain plug securely.
5. After drain the fuel filter, bleed the fuel system.
For bleeding air from fuel system, refer to "Fuel
system (distributor type fuel injection pump) - Bleed
air" (8-5).
Fig. 8-4 Fuel filter - Drain water (2)
When handling fuel, make sure there are no open flames or other fire hazards near the engine.
Wipe off any spilled fuel completely.Spilled fuel can ignite and cause a fire.
Drain plug
Priming pump
158/242

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SDMO R33C3 and is the answer not in the manual?

SDMO R33C3 Specifications

General IconGeneral
BrandSDMO
ModelR33C3
CategoryPortable Generator
LanguageEnglish

Related product manuals