Characteristics of GENLUB TDX 15W40 oil
Performance
GENLUB TDX oil is a 15W40 multigrade mineral oil which meets the following specifications: ACEA E3 and API CG-4.
ACEA E3: oil with superior viscosity stability, suited to extended oil change intervals and severe conditions of use.
API CG-4: oil particularly effective to meet the emissions requirements.
ACEA = European Automobile Manufacturers' Association
API = American Petroleum Institute
Specifications
Specifications Units Grade SAE 15W-40
Density at 15°C kg/m
3
883
Kinematic viscosity at 100°C mm
2
/s (cSt) 14
Viscosity index – 130
Flow point °C - 27°
Flash point °C >200
TBN* mgKOH/g 9.7
Typical values given for information purposes
* TBN (Total Base Number – degree of alkalinity): a measure of a lubricant's reserve alkalinity according to standard ASTMD 2896.
This check makes it possible to assess the ability of the product to remain in service and to check the ’capacity of the lubricant to
neutralise the acidity contained in the oil, which may corrode the metallic elements of the lubricated component.
2.5.3 Coolant specifications
The engine's internal cooling system allows the engine to operate at a precise temperature.
The table below lists the coolants recommended for each engine manufacturer.
Engine
Make Type Make Type
Mitsubishi All
Mitsubishi LLC
GenPARTS GENCOOL PC -26
MTU All GenPARTS GENCOOL PC -26
John Deere All GenPARTS GENCOOL PC -26
Volvo All GenPARTS GENCOOL PC -26
Doosan All GenPARTS GENCOOL PC -26
To Next Page
Loading...
