SDMO R33C3 - Table of Maintenance Operations

7.3. Table of maintenance operations
OPERATIONS
10 h
Daily
250 h 500 h 1000 h 1500 h 3000 h 2 years
20 000 h
3 years
Generator set
• Check the general condition
●
• Check the tightening torques
●
• Check the absence of leaks
●
• Check the condition of battery charge
●
• Clean the battery terminals
●
• Check condition and connections of
electrical equipment
●
• Clean with compressed air the relays and
contactors
●
Engine
• Check engine oil and coolant level
●
• Check fuel filter / Water bowl
●
• Check air cleaner
●
• Replace engine oil and oil filter
a
●
• Inspect belt and adjust and belt tension
●
• Check and Clean radiator fins
●
• Add grease to link joints, etc.
●
• Replace fuel filter (in-line type fuel injection
pump)
●
• Inspect valve clearance
●
• Check glow plug
●
• Inspect starter
●
• Inspect alternator
●
• Retighten bolts and nuts on the engine
a
●
• Clean nozzle tip
●
• Check and Clean fuel injection nozzle
●
• Inspect turbocharger
●
• Change coolant
●
Alternato
r
• Check the tightening torques
After the first 20 hours
• Check the general condition
• Check the various electrical connections of
the installation
• Grease the bearings
●
a
After the first 50 service hours for a new or overhauled engine
82/242