The Parameter menu: to navigate in this menu simply use the arrow buttons separately.
The sub-menus: The sub-menus are available at the end of the parameter menu. To go to these sub-menus, scroll through the
parameters using the ▲ and ▼ buttons until you reach the required sub-menu.
C- The Sub-menus.
The sub-menus enable certain aspects of the fault finding module display to be modified.
Changing the unit of measurement:
There are two display modes available for units: English or metric. To change your units of measurement, use the ▲ and ▼ scroll
buttons until you get to the sub-menu:
Press the ▲ and ▼ arrows simultaneously if you want to retain the current designation.
Press one of the scroll buttons to show the second mode for displaying units. If you want to retain the second display mode, confirm
this by pressing the ▲ and ▼ buttons simultaneously.
To Next Page
Loading...
