Secutron MR-2300T User Manual

70
11.3.2 Command Menu/MR-2300 Config -->Inp Zone
This Inp Zone menu is used to program the process type for the initiating circuits. The
maximum number of initiating circuits is 12. Only those supported by the particular model are
shown in the CFG-300 Configuration Tool.
Note: Refer to section 11.2.1 on page 64 for detailed instructions on making menu
selections.
Command Menu/MR-2300 Config/Ipt.
Zone
1.Process Type (Initiating circuit)
|
|
|
12.
[X] NON-VERIF ALARM
->Default
[ ] VERIF ALARM
[ ] SPRKL ALM
[ ] WTR-FLOW ALM
[ ] NON-LATCH SUP
[ ] LATCH SUPV
[ ] GEN ALARM
[ ] BUILDING
[ ] TRB ONLY
Use this menu to select the
process type of each input
zone. See section 9.7 on
page 51.
i
1 Zone-1
2 Zone-2
--
--
Initiating Zone
12 Zone12
Zone-1 Type
[X] NON-VERIF ALARM
Zone-12 Type
[X] NON-VERIF ALARM

Secutron MR-2300T Specifications

General

Brand	Secutron
Model	MR-2300T
Category	Control Panel
Language	English