Secutron MR-2300T

84
Command Menu/Dialer-Config/Telephone Line
2. Line#2 Dialing Type
[X] DTMF Dial->Default
[ ] Pulse Dial
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
3. Line#1 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Use this menu to let the
system know whether or not
to wait for a dial tone before
dialing. Cell phone setup for
the dialer requires that the
system not wait for dial tone
before dialing.
Command Menu/Dialer-Config/Telephone Line
4.Line#2 wait for Dial tone
[X] ENABLE ->Default
[ ] DISABLE
Same as Line#1.
Command Menu/Dialer-Config/Telephone Line
5.Number of retries
06 ->Default
Set the number of retries for
both line#1 and line#2. This
function lets the dialer retry
on either line if it is busy or
not available. If the retry
count expires, the panel
reports a line trouble.
Note: Refer to section 11.2.1 on page 64 for detailed instructions on making menu
selections.
Line#2 Dialing Type:
[X] DTMF Dial
Line#1 Wait Dialtone
[X] ENABLE
Line#2 Wait Dialtone
[X] ENABLE
Number of Retries:
06
i