Secutron MR-2320 Series - Mechanical Installation; Installing the Enclosure; Figure 1 Box Dimensions, Semi-Flush Mounting and Trim Ring

14
4.0 Mechanical Installation
4.1 Installing the Enclosure
Install the MR-2320 Series panel enclosure as shown below. Mount enclosure surface mount
using the four mounting holes with the provided screws.
Figure 1 Box dimensions, semi-flush mounting and trim ring
Note: Installation, use and maintenance should be in accordance with the
manufacturer’s documents and the National Electrical Code, ANSI/NFPA 70, and
the National Fire Alarm Code ANSI/NFPA 72.
i
17"
22.5"
Adhere trim ring to
wall surface around
the MR-2320 backbox.
PLACE MR-2320 TRIM RING OVER BACKBOX
14.5"
4
.
5
"
11"
20.0"
1.5"
5.425"
14.5"
3.5"
1"
3.5" is the maximum depth
for semi-flush mounting
using the flush trim ring
1" is the minimum depth
above the wall required
for semi-flush mounting
using the flush trim ring
4 Mounting
Holes for
Surface
Mounting