Portable X-ray Units
Service Manual
SM-1076R2
12
2.2.7 DATE AND TIME (FACTORY SET AT GMT +1)
When entering the Date and Time data, keep in mind that they are
not roll over numbers.
1. Select configuration menu C08 to enter the date/time at the RTC (Real
Time Clock).
2. Enter sub-menu:
C8.1 for Hour Configuration (range from 0 to 23).
C8.2 for Minute Configuration (range from 0 to 59).
C8.3 for Date Configuration (range from 1 to 31).
C8.4 for Month Configuration (range from 1 to 12).
C8.5 for Year Configuration (range from 2000 to 2099).
The kVp Display shows (C8.X) and the mAs Display shows the Factory
set values.
3. Press “mAs Increase” or “mAs Decrease” to change the values.
4. Press “Reset” push-button to save values.
5. Press “Collimator Light” push-button to exit sub-menus. The kVp Display
shows (C08).
6. Press and hold first “Collimator Light” push-button and then press “kVp
Increase” push-button, release “kVp Increase” and then release
“Collimator Light” in order to exit Configuration Mode.
Note .
To Next Page
Loading...
