Portable X-ray Units
Service Manual
SM-1076R2
72
5.3 PARTS REPLACEMENT OF THE MONOBLOCK UNIT
DO NOT MANIPULATE INSIDE THE UNIT WITHOUT
DISCONNECTING IT FROM MAINS, RISK OF ELECTRIC
SHOCK.
Configuration and Calibration procedures should only be
performed at field if Portable Control Board, Control Driver
Board or the High Voltage Transformer are replaced or the
EEPROM memory is re-initialized.
Refer to Renewal Parts Section for further information on parts
identification.
X-ray Power Unit
Collimator
Control Panel
Note .
To Next Page
Loading...
