: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 13
40 11 Used to check the multi-purpose tray
width detection adjustment value.
Operation test/Check Paper feed Operation
12 Used to check the multi-purpose tray
width detection adjustment value.
Adjustment/Setup Paper feed Operation
41 1 Used to check the operation of the
document size sensor and the
related circuit. (The operation of the
document size sensor can be
monitored with the LCD display.)
Operation test/Check Other Operation
2 Used to adjust the document size
sensor sensing level.
Adjustment Other Operation
3 Used to check the operation of the
document size sensor and the
related circuit. (The document size
sensor output level can be monitored
with the LCD display.)
Operation test/Check Other Operation
43 1 Used to set the fusing temperature in
each operation mode.
Setting Fixing (Fusing) Operation
3 Fusing roller RPM setting. Setting (Adjustment) Fixing (Fusing) Operation
44 1 Used to set enable/disable of
correction operations in the image
forming (process) section.
Setting Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
Operation
2 Used to perform the gain adjustment
(image density sensor LED current
adjustment) of the image density
sensor and the gain adjustment
(OPC drum marking sensor LED
current adjustment) of the OPC drum
marking sensor.
Adjustment Image process
(Photoconductor)
Operation
4 Used to set the target density level in
the image density correction.
Setting Image process
(Photoconductor/
Developing)
Operation
5 Used to set the reference developing
bias voltage, the reference main
charger grid voltage, and the laser
power in the image density
correction.
Setting Image process
(Photoconductor/
Developing)
Operation
9 Used to check the data related to the
image forming section correction
(process correction) result (corrected
main charger grid voltage, the
developing bias voltage, and the
laser power voltage in each print
mode). (This simulation allows to
check that correction is performed
normally or not.)
Adjustment/Setup/
Operation data output/
Check (Display/Print)
Image process
(Photoconductor/
Developing/
Transfer/Cleaning)
Data Operation data
(Machine
condition)
12 Used to display sampling toner
image patch density data in image
density correction. (Used to check
that the correction is performed
normally or not.)
Adjustment/Setup/
Operation data output/
Check (Display)
Image process
(Photoconductor/
Developing)
Operation
14 Used to check the output level of the
temperature sensor and the humidity
sensor.
Adjustment/Setup/
Operation data output/
Check (Display)
Image process
(Photoconductor/
Developing)
Operation
16 Used to check the toner
concentration control data.
Adjustment/Setup/
Operation data output/
Check (Display)
Image process
(Developing)
Operation
Code
Function (Purpose) Purpose Section Item
Main Sub
To Next Page
Loading...
