Sharp AR-M550U - Page 273

: Feb. 9 2004
1
AR-M550/M620/M700 SIMULATION 8 - 15
46 31 Used to adjust sharpness of the copy
mode.
Adjustment Picture
quality
39 Used to adjust sharpness of the FAX
mode.
Adjustment Picture
quality
45 Used to adjust the image density in
the FAX mode (600dpi).
Adjustment Picture
quality
48 1 Used to adjust the copy
magnification ratio (in the main
scanning and the sub scanning
directions).
Adjustment Optical (Image
scanning)
Picture
quality
5 Used to adjust the copy
magnification ratio in the sub
scanning direction.
Adjustment Optical (Image
scanning)
Picture
quality
50 1 Used to adjust the copy image
position and the void area (image
loss) adjustment on print paper in the
copy mode. (The similar adjustment
can be performed with SIM 50-5 and
50-2 (Simplified method).)
(Document table mode)
Adjustment Picture
quality
Image position
2 Used to adjust the document scan
position, the image print position,
and the void area (image loss).
(Simple adjustment) (This
adjustment is the simple method of
SIM 50-1.) (Document table mode)
Adjustment Picture
quality
Image position
5 Used to adjust the print image
position and the void area (image
loss) on print paper. (Adjustment as
the print engine) (This adjustment is
reflected on all the FAX/printer/copy
modes.)
Adjustment Picture
quality
6 Used to adjust the copy image
position and void area (image loss)
on print paper in the copy mode.
(The similar adjustment can be
performed with SIM 50-7 (simple
method).) (SPF mode)
Adjustment Picture
quality
7 Used to adjust the copy image
position and void area (image loss)
on print paper in the copy mode.
(The similar adjustment can be
performed with SIM 50-6.) (SPF
mode)
Adjustment Picture
quality
10 Used to adjust the print image off-
center position. (Adjusted separately
for each paper feed section.)
Adjustment Picture
quality
Image position
12 Used to adjust the scan image off-
center position. (Adjusted separately
for each scan mode.)
Adjustment Picture
quality
Image position
27 Used to adjust the image loss of the
scan image in the FAX/scan mode.
Adjustment Picture
quality
51 2 Used to adjust the contact pressure
of paper on the resist roller of each
section (each paper feed, duplex
feed and SPF paper feed of the
copier). (This adjustment is required
when the print image position
variations are considerably great or
when paper jams occur frequently.)
Adjustment Paper transport
(Discharge/
Switchback/
Transport)
Operation
Code
Function (Purpose) Purpose Section Item
Main Sub