31
Basic adjustment settings (Analogue)
3
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
1
2
Press a/b to select the optimum colour
system, and then press OK.
MENU
[
Setup
...
Programme Setup
...
Manual Adjust
]
Fine
Colour sys.
Sound sys.
Label
Skip
Decoder
Lock
AUTO
PAL
SECAM
NTSC 4.43
PAL-60
[179.25]
[AUTO]
[B/G]
[Off]
[SAT.1]
[Off]
[Off]
Colour system menu
Press a/b to select “Colour sys.”, and then
press OK.
• Receivable colour systems are listed.
Sound system (Broadcasting system)
3
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
Press a/b to select “Sound sys.”, and then
press OK.
• Receivable sound systems (Broadcasting
systems) are listed.
1
2
NOTE
• If you adjust this setting, please check the colour system
information. (See left column.)
Press a/b to select the optimum sound
system, and then press OK.
Sound menu
Fine
Colour sys.
Sound sys.
Label
Skip
Decoder
Lock
B/G
D/K
I
L
L’
[179.25]
[AUTO]
[B/G]
[Off]
[SAT.1]
[Off]
[Off]
3
2
Labelling menu
4
Press a/b to select “Label”, and then press
OK.
• Alphabets and numbers are listed.
Press a/b/c/d to select each character
of the new name for the channel, and then
press OK.
Repeat the above until the name is fully spelt
out.
• The name can be 5 characters or less.
Labelling channels
When a TV channel sends its Network Name, the auto
installation detects the information and assigns a name
to it. However, you can change individual channel
names.
Press a/b/c/d to select the channel you
want to edit, and then press OK.
• The selected channel information displays.
1
Manual setting for each channel (continued)
Colour system
LC-30AD1E(E)-c 03.10.31, 1:17 PM31