Sharp LC-30AD1E - Input Signal (PC Input Mode Only); Auto Sync; Fine Sync

78
3
4
Useful adjustment settings
Input signal (PC input mode only)
• Some input signals may have to be registered manually
to display properly.
• The pairs of input signals (resolutions) in the list below
are not distinguishable when received. In such case, you
have to set the correct signal manually. After setting once,
it will display when the same signal (resolution) is input
again.
Press MENU and the MENU screen displays.
1
Press a/b to select “Input Signal” and then
press OK.
MENU
[
Setup
...
Input Signal
]
Setup Option
Fine Sync.
Input Signal
Auto Sync.
[English]
[Normal]
Language
Rotate
Press a/b to select the desired input signal
on the display.
640 x 480
848 x 480
(Example)
720g400
848g480
1280g768
640g400
640g480
1024g768
NOTE
• You can only select the “Input Signal” on the Setup menu
when receiving one of the 6 input signals listed above.
2
Press c/d to select “Setup”.
• Setup menu displays.
LC-30AD1E(E)-i 03.10.31, 1:27 PM78