63
Using external equipment
AVC System (rear view)
Decoder
SCART cable
(commercially available)
Watching a decoder image
Connecting a decoder
You can use the INPUT 1 terminal when connecting a decoder and other audiovisual equipment.
Displaying a programme
To watch a decoder image, select “INPUT1” from the
“INPUT SOURCE” menu using b on the remote
control unit or INPUT on the Display.
The setting is stored and can be selected in the “INPUT
SOURCE” menu.
NOTE
• Each time b is pressed, the input source toggles.
• If the decoder image does not come in clearly, you may
need to change the input signal type setting on the “Input
Select” menu.
• It is recommended to connect to the INPUT 1 terminal
when using a decoder for ground wave signal input. If
INPUT1 signals are preset in auto installation or
programme setup, make sure to set “Decoder” to
“INPUT1” in the Programme Setup “Manual” menu. (See
page 32.)
• Refer to your decoder operation manual for the signal type.
• See page 73 for how to select the signal type.
MENU
[
Option
...
Input Select
]
RGBCVBS
INPUT SOURCE
TV
DTV
INPUT1
INPUT2
INPUT3
INPUT4
PC
(For INPUT1 signal)
LC-30AD1E(E)-g 03.10.31, 1:25 PM63
To Next Page
Loading...
Need help?
General
